If the WiFi signal is not strong enough to cover every room of your house, consider the Linksys extender setup re6500, a dual-band extender with a maximum throughput of 867 Mbps and four Gigabit Ethernet ports. The latter is especially suitable for gaming, streaming, and wired devices. Getting the RE6500 set up is very easy: first, plug it to a power outlet close to your router, and when the LED begins to glow orange, you can either go to http://extender.linksys.com (or 192.168.1.1) in a web browser and follow the instructions or apply the WPS method by pressing the WPS button on your router followed by the WPS button on the extender's within two minutes. When it is done, put the RE6500 right in the middle of the router and the dead zone for the best coverage. Keep an eye on its LED: a solid white light indicates a good connection, while a solid orange light indicates a weak link to the router. If there are issues, check the power supply, update the firmware through the admin interface, or reset and re-configure. It will only take a couple of simple steps to make WiFi stronger in your entire house without requiring the use of high-tech skills.